STATE 106
AC frequency too low
Behaviors
The inverter has detected that the AC frequency is below its predefined lower limit. Grid conditions are being tested and as soon as they are within the permissible range again, the inverter will automatically resume feeding energy into the grid.
Status Code Class 1
Class 1 status codes (state codes that start with a one, i.e., 1xx), pertain to anomalies detected at the inverter's AC grid interconnection, specifically parameters such as voltage and frequency. Before the inverter can commence operation, it must detect that the grid is within a ceratain range, for a predefined period of time.
Should the inverter identify the grid is outside these parameters, it will temporarily disconnect from the grid and cease production. Concurrently, the inverter will begin assessing the grid conditions per the stipulated monitoring period (e.g., every 5 minutes). If no further issues are detected by the end of this period, the inverter will automaticaly activate the GPIS SoftStart function gradually increasing its output power, in line with national guidelines, and resume feeding energy into the grid.
STATE 106 applies to:
Primo
Galvo
Symo
IG Plus
CL
Solutions for this Error
Remedies
- Check AC breakers and switches are in the ON position. Check mains AC voltage and frequency at the inverter clamps (Qualified persons only). This error should automatically clear once the grid is back within an acceptable range. If the grid is within operating parameters and this error persists, the device may have an internal failure.
- If this issue persists, the next steps include inspecting internal inverter components and their cabling by a trained Fronius Service Provider to further diagnose this specific issue. Defective components or the device itself may need to be replaced.
Get Help with this Error:
The best point of contact is your original installer
If the orginal installer is no longer available, contact a local Fronius Service Provider
DENVER RESIDENTS: Is your system located in the Denver, CO metro area? CONTACT US